LC Miller Re-Coil Terminal Block Assembly 5181-A
A factor in the popular acceptance of the LC Miller
Re-Coil is the effortless interchangeability of induction heating coils,
made possible by the versatility of the coil mounting bars and their adaptability
to any size or shape of work coil. In this respect, the mounting bars in
Re-Coil Terminal Block Assembly 5181-A are recommended where coil or fixture
design requires special adaptation.
The solid-copper mounting bars are provided with cooling water passages to within
2 inches of coil mounting end. Considerable latitude is allowed for fixture attachment;
simply drill and tap for mounting screws where required, using care to avoid
cooling water passages. To attach coil, first locate the desired positions of
coil ends on the bars. From these points, machine passages of suitable size to
connect with the pre-machined cooling water passages. Align with coil ends inserted
in passage, then silver braze or soft solder to bar. The fitted plugs should
now be silver brazed or soft soldered in the rear opening of the cooling
water passage and the entire unit pressure tested for leaks and flow.
| Catalog Number | |
| 5181-A-3 | |
| 5181-A-4 | |
| 5181-A-5 | |
| 5181-A-6 |
|
| 5181-A-8 |
Note: When ordering, please specify size by catalog number.
*TRADE MARK PAT. NO. 2,866,880
The L. C. Miller Company specializes in design, repair and manufacture of custom coils and fixtures. Engineering assistance is available, without obligation, upon request.